The type B3 is a very small, round, omnidirectional
electret microphone. It has special features that allow it to
withstand moisture and makeup when placed in the hair
or on the body.
Key Features:
Extremely Small : Looks great when you want to see it.
Hides easily when you don't.
Water Resistant: The B3 withstands moisture and perspiration. It will even
survive an overnight bath in your favorite cola beverage.
Makeup Resistant: The protective cap on the B3 is easily removed for
cleaning or replacement when clogged with makeup.
Low Handling Noise: With Kevlar reinforced cable and an ultra thin
diaphragm, the B3 sets a new standard for low handling
noise.
Selectable High Frequency Response: Protective caps change high frequency response.
Handles High Sound Levels: Up to 150dB SPL on 48V Phantom Power
Available in Five Colors: Black, White, Light Skin, Cocoa, Gray
Hardwired Version Specifications:
Frequency Response: 20Hz to 20kHz +- 3dB
Sensitivity (2k ohm load):10mV/Pa for P/N B3P4FF05xxx
1mV/Pa for P/N B3P6FF05xxx
Equivalent Acoustic Noise: 24dB SPL A-Weighted
Maximum Sound Pressure: 150 dB (48V, 1mV/Pa mike)
Power Requirements: 9V to 48V Phantom (4mA @ 48V)
Output Impedance: 600 ohms, balanced
Output Connector: XLR-3 Male (contains preamp)
Dimensions: .23" x .18" (5.8mm x 4.6mm)
Weight: .012 oz (.34 g)
Supplied Accessories: Carrying case, tie clip and wind
screen.
Hardwired Version Specifications:
Frequency Response: 20Hz to 20kHz +- 3dB
Sensitivity (10k ohm load):6mV/Pa Standard Gain
2mV/Pa "Red Band" High SPL
Equivalent Acoustic Noise: 24dB SPL A-Weighted
Maximum Sound Pressure: 140 dB (5V, "Red Band" mike)
Power Requirements: 3 to 12 volts @ 200uA
Output Impedance: 2k ohms
Output Connector: Pigtails or to match transmitter
Dimensions: .23" x .18" (5.8mm x 4.6mm)
Weight: .012 oz (.34 g)
Supplied Accessories: Carrying case, tie clip and wind
screen.